Audio Authority HCX-11 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Microphones Audio Authority HCX-11. Audio Authority HCX-11 Installation guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer

Résumé du contenu

Page 1 - Installation Guide

1 of 34TTTrrraaannnttteeeccc SSS555 WWWiiirrreeellleeessssssMMMiiicccrrroooppphhhooonnneee SSSeeerrriiieeesssInstallation Guide

Page 2 - Contents

10 of 343. To change the selected channel to a Custom single frequencyThis option allows the customer to select 1 of over 1400 available channels.Pres

Page 3 - S5 Series System Overview

11 of 344. Program a transmitter with Bank information via receiver Infra-redportPress and hold the “Jog-wheel” for approximately 3 seconds if the rec

Page 4

12 of 34Miscellaneous SettingsRX SettingsMute/Squelch SettingsThe S5 series uses sophisticated internal mute functions including Pilot Tone,Noise and

Page 5

13 of 34All three of the above functionschange in real time as the option isselected. Rotate the “Jog-Wheel” tounderline EXIT after making yourselecti

Page 6 - Receiver Set-Up

14 of 34Pilot ToneThe S5 series has the ability todisable the pilot tone as a means ofeither identifying outside interferenceor allowing compatibility

Page 7

15 of 34TX SettingsLock TX SwitchTo prevent unauthorised or accidental changes of frequency or gain on atransmitter, or accidentally turning a transmi

Page 8 - Receiver Frequency Selection

16 of 34Handheld Transmitter Set-Up1. Opening The MicrophoneUndo the handheld sleeve by unscrewing the end cap at the base anti-clockwise and then gen

Page 9

17 of 347. Mute SwitchIncorporated in the handheld end cap is aPower On LED and Audio Mute switch. Tomute the audio, flick the switch towards theLED

Page 10

18 of 34Beltpack Transmitter Set-Up1. Battery FittingOpen the battery compartment bysliding the door forward and up. Insert abattery observing the co

Page 11

19 of 346. Beltpack AF Gain AdjusmentTurn the transmitter on and wait for the flashing “decimal point” on the LCD tostop flashing. Press the “Up” or

Page 12 - Miscellaneous Settings

2 of 34Contents3. Introduction, System Overview4, 5. Safety - Important Instructions6 - 7. Getting Started, Receiver Set-Up8 - 11. Receiver Frequency

Page 13

20 of 34Operating HintsTo maximise operating performance Trantec recommends the following:• Ensure good line of sight between the receiver antennae an

Page 14

21 of 34Troubleshooting Guide• No operation of Transmitter Replace the current battery with a fresh one of the correct Alkaline “AA”type.• No RF signa

Page 15

22 of 34S5 System AccessoriesS5RACK 19" Rack mount kit for S5 Receivers (complete with Antenna Mount)S/PSU-U 5-way power supply for 4 x S5.3 / S5

Page 16 - Handheld Transmitter Set-Up

23 of 34S5 System Part NumbersS5.3 Product Codes & DescriptionModel No Description Pwr Supply FrequencyS5.3-HD-D2U UHF Handheld System c/w

Page 17

24 of 34S5.5 Product Codes & Description, cont.Model No Description Pwr Supply FrequencyS5.5-HD-C1E UHF Handheld System c/w Cardioid D

Page 18 - Beltpack Transmitter Set-Up

25 of 34S5 Series Rack Mount Kit19” Rack Mounting for 2 x S5 Series ReceiversThe rack mounting kit is supplied as standard with S5.5 systems, or isava

Page 19

26 of 3419” Rack 1 x S5 Series Receiver with Front Mount AntennaeThe rack mounting kit is supplied as standard with S5.5 systems, or isavailable as an

Page 20 - Operating Hints

27 of 34Multi-Channel Configuration with ADUThe S5 series is designed for simultaneous use of several systems. Ensureeach system is assigned a differe

Page 21 - Troubleshooting Guide

28 of 34Antenna Head AmplifiersTrantec head amplifiers are designed to reduce the effect of long RF antennacable runs between the receivers or ADUs an

Page 22 - S5 System Accessories

29 of 34Mini-XLR Wiring ConnectionsBeltpack Audio Mini-XLR Connections1. Ground2. Bias 5 V3. AF Hi-Z4. AF Load ResistorSolder connections for Mini-XLR

Page 23 - S5 System Part Numbers

3 of 34IntroductionThe Trantec S5 series represents our commitment to our customers byproviding high-quality, reliable Wireless audio links using our

Page 24 - 24 of 34

30 of 34Wiring for Mini-XLR Flying Socket2 Wire MicPin 1: GroundPin 2: 5 VPin 3: AFPin 4: Internal AF load resistorLink pins 3 and 4 and add a 10 K b

Page 25 - S5 Series Rack Mount Kit

31 of 34Technical SpecificationsOverall SystemFrequency Bands available:RF Switching BW: 36 MHz typ.RF grid spacing: 25 kHzRF Bandwidth: < 200 kHzA

Page 26

32 of 34Handheld Capsule SpecificationType: Audio-Technica MU-36B Element: Moving Coil (dynamic)Polar Pattern: Hyper Cardioid Frequency Response: 100

Page 27

33 of 34WarrantyAll Trantec products are guaranteed for a period of 12 months from the date ofpurchase against defects in materials and workmanship. I

Page 28 - Antenna Head Amplifiers

34 of 34CE Declaration of ConformityThis equipment is in compliance with the essential requirements and other relevantprovisions of Directives 1999/5/

Page 29 - Mini-XLR Wiring Connections

4 of 34SafetyOur aim is to supply you with a product that provides you with countlesshours of trouble-free use. In order to achieve this goal we recom

Page 30

5 of 34

Page 31 - Technical Specifications

6 of 34Getting StartedThe S5 series is a high quality, fully featured wireless microphone system withmany features, including an intuitive operating s

Page 32 - 32 of 34

7 of 341. Attach the 2 supplied antennae tothe rear panel TNC antennaconnectors as shown left.2. Connect the AC/DC adaptor intothe DC inlet as marked

Page 33 - Warranty

8 of 34Receiver Frequency SelectionFrequency Selection Options1. To change the selected channel in BANK1Press and hold the “Jog-wheel” forapproximatel

Page 34 - WEEE Statement

9 of 342. To change the selected BankPress and hold the “Jog-wheel” for approximately 3 seconds if the receiver isnot in `34as to enter the MAIN MENU.

Commentaires sur ces manuels

Pas de commentaire