Audio Authority ADX-1616 Spécifications Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
8
Advanced Setup and Remote Control Options
Using the RS-232 Port.
System controllers and PCs can send all setup and control commands as well as receive feedback via the RS-232 serial port.
Important: If a PC is connected directly to the ADX RS-232 port, use a standard serial cable.
The baud rate is set to 9600 by default, but this may be changed using the Front Panel Menu screen “Serial”. The other
connectivity parameters are xed to 8 data bits, no parity, 1 stop bit, and no ow control.
See the table and diagram below for the ADX serial port pinout.
This control method is capable of performing all commands (See Appendix A).
Ethernet
Serial commands can be issued using an Ethernet connection and a telnet program.
There are two LED indicators located next to the Ethernet port on the rear panel that will help in identifying connection
issues:
Link - The Link LED is steadily lit if a connection is detected and ashes when activity is present.
Speed - The Speed LED is off for 10 base T, and on for 100 base T.
Using the Ethernet Port
Use of a telnet client or terminal program on a Mac or PC allows commands to be sent through the Ethernet port on
the ADX. Connect a PC directly to the Ethernet port using a crossover cable, or alternatively use a standard Ethernet hub
or switch and a standard patch cable. Once connected to a PC or network, the ADX by default will attempt to obtain an IP
address automatically using DHCP. To use Static settings, see the detailed instructions on page 9.
5 4 3 2 1
9 8 7 6
GND RX TX
N
Transfer Rate
9600 bps Default (may be changed, see Appendix A)
Data Bits
8
Parity
None
Stop Bits
1
Flow Control
None or Off
Character type
ASCII
Connector
DB-9
Electrical Rat-
ing
Pins 2 and 3, ±15 VDC
Pin out
Pin 2, Tx
Pin 3, Rx
Pin 5, Ground
Shell, Ground
Actual screen from ADX showing Serial Settings
DB-9 connector on rear panel of ADX
P
L
R
L
R
OUT TO AMPLIFIER
ZONES 1 - 8
OUT TO AMPLIFIER
ZONES 9 - 16
USB
ETHERNET
RS-232 SERIAL
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
L
R
L
R
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16INPUT
INPUT
OUTPUT
OUTPUT
1- SLEEVE = +12V
2- RING = GROUND
3- TIP = SIGNAL
800-322-8346 • 859-233-4599
www.audioauthority.com
LINK
SPEED
18V DC
POWER
IR
INPUT
3.5MM
IR
Model ADX-1616 Audio Matrix
ADX Series
Audio Matrix Switcher
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire